It's not possible to display the content of a help file which was copied from a other PC.
Since the first version of the Web Editor has been released there has been many functionalities added. In parallel, new functionality has been added in PCD firmware, Micro Browser Panels (MB Panels PC
With the web-panels mentioned below it's not possible to connect PCD's with S-Bus over RS485 to the web-panel and to display the web-pages stored on the PCD. The only possible connection type to dis
When using the "Belimo MP Bus" FBox library 2.5.303 or older the temperature value from Pt1000 / Ni1000 sensors aren't read correctly. There is the same problem with PG5 2.0 until library $2.6.104.
From firmware version 0D0 it is possible to download the firmware to the PCD2.M150. It is not any more necessary to write the firmware chips (Flash) on an EPROM burner.
If the master is a PCD2 with a PCD7.F750 the maximal configuration is 2942 Bytes I/O. When adding a SBC Slave to the network this limite is reduced to 2048.
Is it possible to order the battery module cover (PCD3.M5xxx) and the I/O covers as spare parts?
On the first PCD3 hardware series (up to HW version D) the port 2 (RS 485) was the most frequent cause for repair. The reason was that no active protection (supressor diodes) could be present due to t
The main application of this FBox is replacing a DX system by a PCD without the need to replace all the XT extensions, too. Therefore the FBox library for the Johnson Controls JCI N2-Bus is designed t
In the system tab from the PG5 2.0 a constant with the symbol name "S.CPU.PcdType" can be found. This constant is created based on the CPU type selected in the Device Configurator and is very useful i
