. Products not supported by PG5 2.0 The following products and protocols are not supported by PG5 2.0: PCD4 and PCD6 S-Bus RIO (used with PCD1.T240) Profibus FMS For existing projects which [...] over serial PGU or S-Bus to the PCD, error message ‘Error 99: Can’t open port comx’ is shown in the PG5 debugger? (FAQ #101977) We have received the information that on an application it was not possible to access with PG5 version 2.1.420 over serial line (RS232) in PGU or S-Bus mode to the PCD and the message: Error 99: Can
. Products not supported by PG5 2.0 The following products and protocols are not supported by PG5 2.0: PCD4 and PCD6 S-Bus RIO (used with PCD1.T240) Profibus FMS For existing projects which [...] over serial PGU or S-Bus to the PCD, error message ‘Error 99: Can’t open port comx’ is shown in the PG5 debugger? (FAQ #101977) We have received the information that on an application it was not possible to access with PG5 version 2.1.420 over serial line (RS232) in PGU or S-Bus mode to the PCD and the message: Error 99: Can
. Products not supported by PG5 2.0 The following products and protocols are not supported by PG5 2.0: PCD4 and PCD6 S-Bus RIO (used with PCD1.T240) Profibus FMS For existing projects which [...] over serial PGU or S-Bus to the PCD, error message ‘Error 99: Can’t open port comx’ is shown in the PG5 debugger? (FAQ #101977) We have received the information that on an application it was not possible to access with PG5 version 2.1.420 over serial line (RS232) in PGU or S-Bus mode to the PCD and the message: Error 99: Can
An external device like scada or supervision sytem can know the status of the PCD (Run, Halt, Stop or Conditioanl Run) by using a special item of the S-Bus OPC-Server or by using a special S-Bus telegram.
CONTRÔLEUR POUR VENTILO-CONVECTEUR Modules K.DDC.L755 and K.DDC.L757 avec protocole S-Bus
The PCD1.Room is able to handle up to 10 S-Bus and 10 Modbus slaves.
Romutec's Auto-Detect-Modus ist nicht zum neuen Secure Data Mode (SData) des SBC S-Bus kompatibel.
The SBC.Net WebConnect does provide an own driver for S-Bus Communication for most of the communicaiton methods (Ether-S-Bus, Serial-S-Bus and Profi-S-Bus). However, in some cases the SComm driver is required. This FAQ indicates where the WebConnect is looking for the drivers.
In principle, it is possible to use RS422 as physical layer for Serial-S-Bus communication. But note that the S-Bus full protocol is not fully applicatively due to the reason described below!
Remote input/output modules with serial S-Bus interface - type RAIL (top-hat rail mounting) Digital input module: - 10 inputs 24 VDC/VAC
