Third party solutions

Software SCADA software Saia PCD Supervisor Third party solutions

General
FAQ

Documentation

Saia PCD® Supervisor Redundancy

Brochure 31S707 Saia PCD® Supervisor Redundancy

Saia PCD® Supervisor

High Availability and Redundancy

How to operate Supervisor under virtualized ‘always on’ environments.

ENG02			.pdf	0.79 MB	Download
FRA02			.pdf	0.78 MB	Download
GER02			.pdf	0.78 MB	Download
ITA02			.pdf	0.79 MB	Download
SPA02			.pdf	0.77 MB	Download

PCD3 / Sxxx

How can a BACnet Operator Workstation (B-OWS) know that a PCD has been restarted? (FAQ #101452)

There's the possibility to configure a "Restart Notification Recipient" list in the BACnet configurator.

You have to add manually the address of the BACnet device you want to alarm in case of restart of the local PLC. This address is added in the “Restart Notification Recipients” list as shown in the below attached picture. With this setting the PCD will inform the BOW after a restart.
Please makte sure that the device you want to alarm supports this Restart Notification (available since standard 135-2004 addendum b).

Remark
There's a parameter in the BACnet telegram (list of values -> propertyValue -> last-restart-reason) that indicates the restart reason. It's "1" for a cold start (power on the PLC) and "2" for a warm start (restart after progrm download).
It is possible to enter BACnet device ID's or adresses. Take care that if you enter a recipient based on a adress, the MAC-Adress is atually the IP Adress of the recipient.

The requested software / document is no longer marketed by Saia-Burgess Controls AG and without technical support. It is an older software version which can be operated only on certain now no longer commercially available products.