Beginning in May 2010 (calendar week 18) the PCD7.R400 have been equipped with a new flash memory component because the previously used type has no longer been available on the market. This FAQ conta
No. Changing modules under tension can result in damage to the modules and CPU.
The S-Bus Data-Mode was the last implemented S-Bus protocol. Therefore not all PCD's and not all firmwares are supporting the Data-Mode.
Basically on PCD systems introduced before 2003 there are some restrictions to be considered about the maximum baud rate of serial communications. Depending on firmware and hardware not all serial po
The FBox 'MP Single' does indicate a Error and the code 23 (Timeout error) is displayed on the FBox. This might happen when importing an older PG5 project (PG5 1.4.300 or 2.0) which work fine before
In january 2013 a new firmware package for BACnet (to be loaded to the PCD3/7.R560 or PCD3/7.R561) was created (containing BACnet firmware 1.16.77). The main reasons for this new firmware are listed i
the minimum firmware version for PCD3.M5540 hardware version D is V023
Using the SBC CAN Configurator only a Data Mapping for CAN Bus can be created, in this type of configuration the diagnostics and the parametrisation is very limited.
PG5 2.1.310 shows wrongly the path of PG5 2.0 Update Manager. This happens when PG5 2.0 was installed after PG5 2.1!
If an EPROM of a programm with IP-address is made with PG5 1.3.120 the IP-adresse will not be stored in the EPROM (Hex-File)
