Due to a restriction of the firmware before SV 1.08 of the PCD7.L60x room controllers, the Fan Speed output of the devices in RIO mode are not working correctly. This phenomenon can also occur if a to
By default, the outputs of a the modules mounted on a PCD3.T360 RIO will be reset on bus failure (or if the master is in STOP or HALT). This is the general defualt behaviour on Profubus DP networks th
The error above appears when opening the project created in PG5 1.3 with PG5 1.4
In some occasions (e.g. the Technology Camp 2011) it was recommended to the participants of the meeting to install the latest PG5 2.0 version in parallel to the PG5 2.0.150. Please note that once PG5
The first time the MicroBrowser on a CE Panel (PCD7.D5xxx) is launched, it prompts for the start page to be opened. But if the checkbox "ask me again" once has been unchecked, there is no more prompt
No, it's not allowed to load a PCD3 xx7 with a firmware SBC standard operation system.
The Error LED of the PCD2.M127 does blink in case a PCD2.F7xx module is configured but the communication (Profibus or LON) is not working (e.g. because the module itself or a configured Profibus DP sl
We strongly recommend using the FBoxes for analogue modules! In case this is not possible, please refer to the example project "Reading analogue input signals in Instruction List" on the "Getting Star
In february 2010 a new firmware version for the systems PCD2.M177 and PCD.Smart.M177 has been introduced into production. The reason for this introduction is that a new type of flash is used on the PC
This FAQ explains the possibilities in case a PG5 project is not available but still an existing application needs to be modified.
