Your search returned 639 results

11. Networking

    Relevance:

     

    35%

    Miscellaneous S-Bus, S-Bus on Ethernet TCP/IP DK3964R, MPI, RK512 BACnet, EIB, GENIbus, LON, MP Bus, M-Bus AS-i, Modbus, Modbus/TCP/UDP, Profibus [...] 's, PCD1.M137 , PCD2.M127 , PCD2.M157 , PCD2.M177 Not available on the classic CPU's S-Bus General [...] 's. Details about how to plan S-Bus networks can be found in the documentation area. A system partner provides a tool that allows to optmize the S-Bus communication by setting priorities for different telegrams

12. PCD7.H104SE S0-Pulse Counter with S-Bus Interface

    Relevance:

     

    35%

    S0 pulse counter with S-Bus interface

13. PCD2.M480: minimum firmware version for USB, Profi-S-Bus, Profi-S-IO, Multiple S-Bus PGU Ports

    Relevance:

     

    34%

14. Why goes the PCD3 in HALT with a BUS Error when changing the Profi S-Bus configuration in the hardware settings

    Relevance:

     

    33%

    Changing the Profi S-Bus settings puts the CPU in HALT with a BUS Error

15. Why does the Profi S-I/O Bus stopps when connecting an ESA terminal over Profi S-BUS

    Relevance:

     

    32%

    A Profi S-I/O Network is communicating properly. When the ESA terminal is connected to the networt too, the Bus stops for a while.

16. What is the S-Bus address of my S-Energy Manager?

    Relevance:

     

    31%

    By default the S-Energy manager (PCD7.D4xxE) does have the S-Bus address 2 as written in the manual.

17. Why is the "SASI S-Bus Master" FBox red when communicating with S-Energy Meters?

    Relevance:

     

    31%

    Because the energy meters have a slower S-Bus interface the "SASI S-Bus Master" FBox gets red when communicating with energy meters. This red LED can be ignored (or the FBox SEnergyInit can be used; this FBox does not get red on every retry but only if the Energy Meter does not answer at all).

18. Why the S-Bus communication over TCP/IP between PCD’s doesn’t work anymore?

    Relevance:

     

    31%

    If the S-Bus communication over TCP/IP between PCD’s does not work, then do check on the TCP/IP settings table of the PG5 project manager that the field “use” is checked for each line (device) which have to communicate over S-Bus TCP/IP. It’s possible that after an import of a PG5 1.4 project in to PG5 2.0 the field “use” on the TCP/IP settings table is unchecked and therefore the communication over S-Bus TCP/IP doesn’t work.

19. Why is it not possible to communicate over S-Bus with the S-Energy meter (ALD1/ALE3/AWD3)?

    Relevance:

     

    31%

    Due to a firmware problem it isn't possible to use the following S-Bus addresses for the energy meter ALD1, ALE3 and AWD3: 107, 153, 226 and 238.

20. PCD7.H104S S0 to S-Bus module

    Relevance:

     

    31%