How to configure the S-Bus address on a ALE3?

FAQ #101476

The S-Bus address of an ALE3 with Serial-S-Bus interface can be configured by the following procedure.

 

Setting the S-Bus address

  • Navigate to the "Tariff 1 total" (the blue bar must be right below "T1total"; it can be moved with the "arrow down")
  • Press the button with the "arrow right" (>) during 3 seconds
  • Change the address to the value desired
    the "arrow down" increments the address by 10
    the "arrow right" increments the address by 1
  • Once the correct address is displayed/set, wait for until the display turns back to the default display (after around 10 to 15 seconds)

Categories

CC Control Components

CC Control Components / AAE3 / ALE3 / AWD3

Last update: 18.05.2015 02:54

First release: 29.07.2010 15:43

Views: 4819

The requested software / document is no longer marketed by Saia-Burgess Controls AG and without technical support. It is an older software version which can be operated only on certain now no longer commercially available products.

Download