In this case the DP profile: "Universell DP / FMS" has to be chosen. Other protocols won't work due to timing problems.
This outphased product has been a D-SUB 9-pin adapter for the PCD7.F5xx card on a PCD1.M1x0 CPU. The product has been discontinued in 2011 (repair service until end of 2013).
Due of a firmware error it's possible that on the history of the PCD3.M5340 there is an entry "Resistors Fail".
In case of a configuration problem with an Smart Ethernet RIO (PCD3.T665 or PCD3.T666) an according error message is displayed in the PCD history and the PCD stays in HALT. This FAQ lists the signific
In case a backup from/to the flash card (e.g. a PCD7.R500) can not be executed (due to the reasons listed below) this following message is displayed by PG5: "Failed to copy to/from Flash. Check Flash
On a build of a Profibus-DP or Profi-S-IO configuration file which contains a DP or S-I/O slave which has a huge configuration (more than 255 Byte) then this error message is shown.
When configuring a W525 module using the Device Configurator or the Profi-S-I/O (or Profibus DP) Network Configurator, the PCD2/3.W525 does need two registers for the analogue outputs and 8 registers
In case a thermocouple sensor is connected with the wrong polarity, the FBox (or the FB) will indicate this with the error "underrange" or "underflow".
If there is a missing PPO in a Web-Editor project, a build from PG5 will fail with the error 31.
Strange symbol names similar to "aaaaaaabc" in a Web Editor project are most likely the result of *.teq file confusion.
