After a successful program download the software is going to initialize the chosen interface. If this process cannot be finished successfully, an error flag will be forced and into the "master box" (s
If the "MDLS144/288 Data9600 onbit" modem is connected to a "non Saia PCD® COSinus" system (PCD1.M1, PCD2.M1) then it's possible to establish a modem connection to those systems but if the same modem
When connecting a PCD over modem (with PG5 or S-WebConnect) and the connection isn't working at all or is interrupted after a short while, the data compression could be the reason.
If the modem is connected to the PGU port the handshake needs to be "FULL" in PG5 2.0. In PG5 1.4 it worked fine if the handshake was "Default".
With the FBox "L60x Config" the same configuration has been downloaded to all the PCD7.L60x modules but not all have the same operating mode!
If the "Electric Heat" output K 1/2 of the PCD7.L60x room controllers is written to 100% in RIO mode, it is still switched off after around 15 minutes for 2 minutes.
In the english version of the FBox library for the Energy meters ALE3 with Serial-S-Bus interface the symbol names have been mixed up so that the same value appears as "T1part" and as "T2 part" (parti
On the first PCD3 hardware series (up to HW version D) the port 2 (RS 485) was the most frequent cause for repair. The reason was that no active protection (supressor diodes) could be present due to t
Most sensors with current output work with a range of 4..20 mA. Nevertheless it is possible measuring the range 0..20 mA with the analogue input modules for PCD systems.
In case a version of an Omnio receiver or transceiver which requires "Acknowledge telegrams" has been used, the reaction to signals from EnOcean sensors can be very slow in case the wrong FBox is used
