When trying to copy a smart Ethernet RIO station from the menu "Edit" --> "Copy RIO" in the Saia PG5® RIO Network Configurator the following error message appears if the RIO contains a Web Editor pro
Due to a restriction of the firmware before SV 1.08 of the PCD7.L60x room controllers, the Fan Speed output of the devices in RIO mode are not working correctly. This phenomenon can also occur if a to
While the serial PGU port of systems before the PCD3 did always work as PGU port when connecting a PCD8.K111, the serial PGU port of the PCD3 can be configured for using a modem. If this is done, it i
Due to a problem of the firmware version 039 the serial PGU connection on the PGU port does not work.
After an Ethernet module has been replaced (and the IP address remained the same), it is often not possible connecting to the according PCD. The reason is that the PC "remembers" the old MAC address (
When using firmware version 1.08.23 the Profi S-Bus address can only be set one time on the PCD3.M6540 port 2.
When using the EIB/KNX driver FBox "EIB driver FT1.2" with PG5 2.0.200 (and the EIB FBox library SP2.6.210) the build of the project fails due to a fatal error.
Due to an error of the CAN FBox library 2.6.100 an imported project (written in PG5 1.4) can not be compiled in PG5 2.0.110.
When assigning a fixed base address to the symbols of the "Cooling start range" in the adjust parameters from the FBox "MP 6 Way", the build of the PG5 project due fail due to an error.
In case a PG5 project has been created in PG 5 1.4.300 without patch 7 or later installed (or in a beta version of PG5 2.0, a $ version) the PCD3 compact was in pilot phase. At this time it wasn't pos
