If a S-Bus communication is used between the PCD3 or PCD2.M5xx0 and the MB VGA panel (PCD7.D457Vxxx and PCD7.D410Vxxx) then it may not be possible to write to the PCD variables (depending of the firmw
Due to a very low demand from the marked the product PCD7.D435TLCF (3.5" MB Panel) has been phased-out by the end of July 2010.
The fan optimizer COU24-A-MP from Belimo is used together with VAV controllers. However, this device is optimizing the fan based on a signal given from the VAV and can not be addressed and controlled
No, do not connect the RJ45 connector of a Ethernet Port of a PCD directly to Power over Ethernet (PoE). The RJ45 Ethernet port of the PCD will be destroyed if connected directly to PoE (Mode B) beca
There is a problem when placing a communication module PCD3.F1xx and a memory module (PC3.Rxxx) on the same PCD3.
An existing Graftec file can't be open. The CPU of the PC show up to 100% performance!
The compiler sets automatically the correct constant type if it don't match to the instruction.
The Touch Screen Terminal loose the calibration from time to time.
The system catalog mentionned 6 digital inputs (24 Volt, 4 x interrupts) and 2 digital outputs (2 x PWM, 24V 100 mA). But in reality only 4 digital inputs (not 6) are available at the moment and 2 dig
Most sensors with current output work with a range of 4..20 mA. Nevertheless it is possible measuring the range 0..20 mA with the analogue input modules for PCD systems.
