The download seems to start but blocks imediatly. The task has to be killed by the task manager.
When trying to create a Hex-File the message: "Failed to initialize the hex file generator" appears
Due to a bug the PCD diagnostic file cannot be recorded automatically with PG5 1.4 over a modem connection. The attempt to record a file fails due to a timeout and the Online Debugger remains open aft
There are some restriction on the PCD2.M480, the port 1 as Master Port doesn't support parity mode. Note: The "Break mode" is not supported on the PCD2.M480!
It's not possible to display the content of a help file which was copied from a other PC.
Since the first version of the Web Editor has been released there has been many functionalities added. In parallel, new functionality has been added in PCD firmware, Micro Browser Panels (MB Panels PC
With the web-panels mentioned below it's not possible to connect PCD's with S-Bus over RS485 to the web-panel and to display the web-pages stored on the PCD. The only possible connection type to dis
When using the "Belimo MP Bus" FBox library 2.5.303 or older the temperature value from Pt1000 / Ni1000 sensors aren't read correctly. There is the same problem with PG5 2.0 until library $2.6.104.
From firmware version 0D0 it is possible to download the firmware to the PCD2.M150. It is not any more necessary to write the firmware chips (Flash) on an EPROM burner.
If the master is a PCD2 with a PCD7.F750 the maximal configuration is 2942 Bytes I/O. When adding a SBC Slave to the network this limite is reduced to 2048.
