The handling of the @CO_ and @COFF_ expressions on the Web-Editior8 has been changed on PG5 2.3.192. More information can be found on the attached document.
How to get back the Graphic Editor (Edit mode) window from the secondary (other) Monitor in Windows 7.
If for example a Scada system communicate over S-Bus slave gateway port or S-Bus PGU port with a slave station via a master gateway port then after a programm download to the gateway PCD (or if the ga
If the PCD2/3.W220Z18 card is plugged in to a ‘Power PCD‘ or a PCD2.C1000 or PCD2.C2000 and if all 8 analog inputs channels of the PCD2/3.W220Z18 module are connected to 8 PT100 sensors then the measu
Yes it’s possible to use BACnet on both ports ETH1 or ETH2 of the PCD3.M6860. In PG5 it’s possible to activate at the same time BACnet on ETH1 and ETH2 but we strongly recommend to use/activate
Displays which left the factory by the beginning of November 2016, were shipped with a new equipped “black” SD Card. This new “black” SD Card does not offer the exactly same amount of bytes as the o
Up to FW Version SV2.01 of the PCD7.L60x room controller, only the groups 3 and 4 of "light on/off" or "shades up/down" can be controlled on the PCD7.L645W/B. The groups 1 and 2 can only be controlled
When using the FBox "ABS Init" (version 2.6.197 or earlier) with the mode "Downtime", the switching on and off of the motors / pumps won't work after elapsing of the defined downtime time (1 hour in s
On the master PCD the I/O mapping to Register 4096 until Register 16'383 for RIO-networks (Profibus DP or Profi-S-I/O) doesen't work on PCD3 and PCD2.M480 and PCD2.M5xx0 systems with firmware version
The diagnostic flag Slave_Err does indicate that at least one Profibus slave has an error. The error could be that the slave(s) is/are not connected to the Profibus network or that the slave(s) is/ar
