The online paramters of the "Call SMS" FBox should be adapted in runtime. Per example inserting another destination for the "Call SMS" FBox. For some reason the updating of the callnumbers is not work
Because new instructions have been defined, user programs with Heavac Dialog FBoxes can in some cases no longer be built.
There are error messages displayed for each old FBox that it should be replaced.
Due to an error in the PG5 device template file of PG5 2.0.200 it’s not possible to switch on/off the relay outputs of the PCD3.WAC CPUs. (PCD3.M2230A4T5, PCD3.M2330A4T1, PCD3.M2330A4T3, PCD3.M2330A4T
Due to an error in the PG5 device template file of PG5 2.0.200 it’s not possible to switch on/off the digital outputs of the PCD3.compact CPUs. (PCD3.M2030V6, PCD3.M2130V6)
It is absolutely necessary to enable the motor driver after the initialisation of an H3xx. Otherwise the motor will move unintendedly and uncontrolled.
If the symbol editor's option "Add symbols to global table" in PG5 1.3 is checked, a message saying that this is a very bad programming practice will be displayed. Some of the reasons for this stateme
There is a problem with the Westermo-Modem TD-35 when using other baudrates than 9600. Westermo will correct it.
Probably the property of the referenced Object is not setup to be writable.
The Reset LED on the Power Supply is activ if the Power is too low (
