If the PCD2.F2610 or PCD3.F261 Dali communication modules are used: There is no need to use a Tridonic interface. The whole DALI configuration is done with the Dali F-Box over the F2610/F261 modules
When using the SBC.Net WebConnect on a PC or an eXP Panel you have to "terminate" the WebConnect task every time you shut down the PC.
The SBC.Net WebConnect does provide an own driver for S-Bus Communication for most of the communicaiton methods (Ether-S-Bus, Serial-S-Bus and Profi-S-Bus). However, in some cases the SComm driver is
The reason for the error message is not clear and there is no multi-defined symbol in the new transition.
If a S-Bus communication is used between the PCD3 or PCD2.M5xx0 and the MB VGA panel (PCD7.D457Vxxx and PCD7.D410Vxxx) then it may not be possible to write to the PCD variables (depending of the firmw
Due to a very low demand from the marked the product PCD7.D435TLCF (3.5" MB Panel) has been phased-out by the end of July 2010.
The fan optimizer COU24-A-MP from Belimo is used together with VAV controllers. However, this device is optimizing the fan based on a signal given from the VAV and can not be addressed and controlled
No, do not connect the RJ45 connector of a Ethernet Port of a PCD directly to Power over Ethernet (PoE). The RJ45 Ethernet port of the PCD will be destroyed if connected directly to PoE (Mode B) beca
There is a problem when placing a communication module PCD3.F1xx and a memory module (PC3.Rxxx) on the same PCD3.
An existing Graftec file can't be open. The CPU of the PC show up to 100% performance!
