Why is the message: "no card echo" displayed in the "Master Box"?
FAQ #100599
After a successful program download the software is going to initialize the chosen interface. If this process cannot be finished successfully, an error flag will be forced and into the "master box" (single or duplex) the text "no card echo" will be shown.
Problem
After a successful program download the software is going to initialize the chosen interface. If this process cannot be finished successfully, an error flag will be forced and into the "master box" (single or duplex) the text "no card echo" will be shown.
Reasons
- Wrong channel definition (Port address of the PCD system)
- PCD2.T500 – wrong wiring to or from the serial interface of the PCD
- Wrong base address into the FBox "Master-Duplex"
- Physically not existing MP-interface card
- Defect MP-interface card
Solution
Check and correct the calibration and wiring and the MP interface card.
Categories
PG5 2.0 / MP-Bus
Last update: 27.05.2015 22:27
First release: 24.08.2006 13:07
Views: 986
