PCD7.D230 with hardware version C or D is hard or impossible to operate

FAQ #100283

 

If too much force is applied to the rotary button it can happen that the print with the electronics within the terminal moves out of its normal position, which makes it difficult or impossible to operate the terminal.

 

Temporary solution: draw on the rotary button until the print is in its original position

Permanent solution: ask your SBC representative for a matching screw and isolation washer so you can secure the print as shown below:

image

 

Related Files:

Categories

PCD7 / D23x

Last update: 18.05.2015 19:12

First release: 22.12.2004 16:35

Views: 3680

The requested software / document is no longer marketed by Saia-Burgess Controls AG and without technical support. It is an older software version which can be operated only on certain now no longer commercially available products.

Download